Small screw press for proper use
2013-10-18 by seoer9
In recent years, rural areas using a small screw press more and more, but some users because there is no master use of technology, resulting in the oil is low,pellet machine, or even fail. Small screw press right now using the method described below: 1, before: first adjustment pressing screw shaft and the cake gap, so that the pressing screw axial rake hilarious pie mouth, and then backwards 2-3 laps, the gap controlled at 0.5 to 1.0 mm
2, into juice before: Should the oil press idle for 3-5 minutes, then slowly and evenly cake or raw material feed, the machine bore friction heat. Feeding more dry, the body temperature Can be higher, and vice versa can be lower. Usually the body temperature of 70-80 degrees Celsius, before commencing crushing. 3, when the press: should slowly adjust cake thickness, oilseeds varieties, press the number of times is different, the general control of the cake thickness 0.25-0.5 mm. When the That job satisfaction, you can flip the hand lever locking adjustment nut to oil plants feed to the normal feed rate. If the cake sluggish or stops the cake, you should stop feeding , Taking the feed adjustment board, exclude inlet deposit material, and then slowly withdraw the spindle, clear virgin bore obstruction. Pressed sesame, peanuts and other oil yield higher Oil, you can even squeeze two or three times in batches, each batch of 5 kg is appropriate.